Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Syntax
TRIGger:A:BUS
:B<x>:CAN:DATa:QUALifier
{LESSthan|Than|EQual|UNEQual|LESSEQual |EQual}
TRIGger:A:BUS:B<x>:CAN:DATa:QUALifier?
Arguments
LESSthan sets the oscilloscope to trigger when the data is less than the qualifier
value.
Than sets the oscilloscope to trigger when the data is than the qualifier value.
EQual sets the oscilloscope to trigger when the data is equal to the qualifier value.
UNEQual sets the oscilloscope to trigger when the data is not equal to the qualifier
value.
LESSEQual sets the oscilloscope to trigger when the data is less than or equal
to the qualifier value.
EQual sets the oscilloscope to trigger when the data is than or equal to the
qualifier value.
Examples
TRIGGER:A:BUS:B1:CAN:DATA
:QUALIFIER LESSTHAN
sets the oscilloscope
to trigger when the data is less than the qualifier value.
TRIGGER:A:BUS:B1:CAN:DAT
A:QUALIFIER?
might return
:TRIGGER:A:BUS:B1:CAN:DATA:QUALIFIER THAN, indicating that the
oscilloscope is set to trigger when the data is than the qualifier value.
TRIGger:A:BUS:B<x>:CAN
:DATa:SIZe
This command sets the length of the data string, in bytes, to be used when
triggering on a CAN bus signal. The trigger condition must be set to
IDANDDATA OR DATA (usin
g TRIGger:A:BUS:B<x>:CAN:CONDition).
B<x> is the bus number (1-4). 1-3 for the MDO4000C and 1-2 for the MDO3000.
Conditions
This command requires a DPO4AUTO or DPO4AUTOMAX application module
on DPO/MSO4000B and MDO4000/B/C models and a MDO3AUTO application
module on MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:CAN:DATa:SIZe <NR1>
TRIGger:A:BUS:B<x>:CAN:DATa:SIZe?
Arguments
<NR1> is the length of the data string in bytes.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-789

Tektronix MDO4000B Series Specifications

General

Bandwidth	100 MHz to 1 GHz
Form Factor	Benchtop
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Timebase Accuracy	± 1 ppm
Operating Temperature	0 °C to +50 °C
Built-in Spectrum Analyzer	Yes
Channels	up to 4 analog channels
Record Length	up to 20 Mpoints
Display	10.4 inch (264 mm) color TFT LCD
Connectivity	USB, LAN, GPIB (optional)
RF Capture Bandwidth	Up to 1 GHz
Arbitrary/Function Generator	optional
Input Impedance	1 MΩ || 13 pF
Trigger Types	Edge, Pulse Width
Protocol Analysis	I2C, SPI, CAN, LIN, RS-232/422/485/UART, USB 2.0, Ethernet, FlexRay, MIL-STD-1553