Commands Listed in Alphabetical Order
TRIGger:A:BU
S:B<x>:LIN:DATa:VALue
This command specifies the binary data string to be used for LIN trigger condition
if trigger condition is ID or IDANDDATA.
Conditions
This command requires a DPO4AUTO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AUTO application module for
MDO3000 mo
dels.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:LIN:DATa:VALue <QString>
TRIGger:A:BUS:B<x>:LIN:DATa:VALue?
Arguments
<QString> is a quoted string that is the LIN trigger data value.
Examples
TRIGGER:A:BUS:B1:LIN:DATA:VALUE “11001101”sets the data value to
11001101.
TRIGGER:A:BUS:B1:LIN:DATA:VALUE? might return
TRIGGER:A:BUS:B1:LIN:DATA:VALUE "XXXXXXXX" indicating the
data value is don't care.
TRIGger:A:BUS:B<x>:LIN:ERRTYPE
This command specifies the error type be used for LIN trigger. B<x>
Conditions
This command requires a DPO4AUTO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AUTO application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:LIN:ERRTYPE
{SYNC|PARity|CHecksum|HEADertime|RESPt ime|FRAMetime}
TRIGger:A:BUS:B<x>:LIN:ERRTYPE?
Arguments
SYNC sets the LIN error type to SYNC.
PARity sets the LIN error type to parity.
CHecksum sets the LIN error type to checksum.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-829
To Next Page
Loading...
