Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Examples
TRIGGER:A:RUN
T:WHEN MORETH AN
sets the runt trigger to occur when the
oscilloscope detects a runt in a pulse wider than the specified width.
TRIGGER:A:RU
NT:WHEN?
might return :TRIGGER:A:P ULSE:RUNT:WHEN
OCCURS
indicating that a runt trigger will occur if the oscilloscope detects a runt
of any detectable width.
TRIGger:A:
RUNT:WIDth
This command specifies the width, in seconds, for a runt trigger.
To set the trigger voltage threshold level for the edge, pulse width, runt,
or transition (rise/fall or slew rate) trigger, use TRIGger:A:LEVel:AUXin,
TRIGger:A:LEVel:CH<x>,orTRIGger:A:LEVel:D<x>.
Group
Trigger
Syntax
TRIGger:A:RUNT:WIDth <NR3>
TRIGger:A:RUNT:WIDth?
Related Commands
TRIGger:A:RUNT:WHEn
Arguments
<NR3> is a floating point number that specifies the minimum width, in seconds.
Examples
TRIGGER:A:RUNT:WIDTH 15E-6 sets the minimum width of the pulse runt
trigger to 15 µs.
TRIGGER:A:RUNT:WIDTH? might return : TRIGGER:A:PULSE:RUNT:WIDTH
2.0000E-09
indicating that the minimum width of a pulse runt trigger is 2 ns.
TRIGger:A:SETHold? (Query Only)
Returns the clock edge polarity, voltage threshold and source input; data voltage
threshold and source; and both setup and hold times for setup and hold violation
triggering.
Group
Trigger
Syntax
TRIGger:A:SETHold?
2-898 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English