Inspection and Cleaning
5. Spray wash dirty parts with the isopropyl alcohol and wait 60 seconds for
the majority of the alcohol to evaporate.
6. Use hot (120°F to 140°F) deionized water to thoroughly rinse them.
7. Dry all parts with low-pressure, deionized air.
8. Dry all components and assemblies in an oven or drying compartment
using low-temperature (125°Fto 150°F) circulating air.
Lubrication
There is no periodic lubrication required for this power supply.
6
"
8
Maintenance
To Next Page
Loading...
