Tektronix TDS1002

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−175
WFMPre:<wfm>:PT_Fmt
Same as WFMPre:PT_Fmt, except that <wfm> specifies the
source/destinaton waveform instead of DATa:SOUrce and
DATa:DESTINATION. For set commands, if <wfm> is not a
reference waveform, the oscilloscope generates error 2241.
WFMPre:<wfm>:PT_Off
Same as WFMPre:PT_Off, except that <wfm> specifies the
source/destinaton waveform instead of DATa:SOUrce and
DATa:DESTINATION.
For set commands, if <wfm> is not a reference waveform, the
oscilloscope generates error 2241.
Otherwise, the set form of this command is ignored.
WFMPre:<wfm>:WFId? (Query Only)
Same as WFMPre:WFId?, except that <wfm> specifies the source
waveform instead of DATa:SOUrce.
WFMPre:<wfm>:XINcr
Same as WFMPre:XINcr, except that <wfm> specifies the
source/destinaton waveform instead of DATa:SOUrce and
DATa:DESTINATION.
For set commands, if <wfm> is not a reference waveform, the
oscilloscope generates error 2241.