Tektronix TDS1002 Programmer's Manual

Command Descriptions
2−50
TDS200/1000/2000 Series Oscilloscope Programmer Manual
FAIL indicates that the oscilloscope detected errors during the last
calibration operation, or that no calibration operations have been
performed since power up.
CALibrate:STATUS?
might return CALIBRATE:STATUS FAIL if the oscilloscope failed the
last calibration operation.
CH<x>? (Query Only)
Returns the oscilloscope vertical parameters. Because CH<x>:SCAle
and CH<x>:VOLts are identical, only CH<x>:SCAle is returned.
Vertical
CH<x>?
Oscilloscope vertical parameters
CH1?
might return the string :CH1:SCALE 1.0E0;POSITION 0.0E0;
COUPLING DC;BANDWIDTH OFF;PROBE 1.0E0 for channel 1.
SELect:CH<x>
CH<x>:BANdwidth
Sets or queries the bandwidth setting of the specified oscilloscope
channel. This command is equivalent to setting the BW Limit option
in the Vertical menu.
Examples
Group
Syntax
Returns
Examples
Related Commands

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz