Tektronix TDS1002 Programmer's Manual

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−51
Vertical
CH<x>:BANdwidth { ON | OFF }
CH<x>:BANdwidth?
ON sets the channel bandwidth to 20 MHz.
OFF sets the channel bandwidth to the full bandwidth of the
oscilloscope.
In most acquisition modes, full bandwidth is 60 MHz, 100 MHz, or
200 MHz (depending on the oscilloscope model). There are
exceptions.
TDS1000 and TDS2000 Series
At vertical scales from 2.00 to 4.99 mV/div (sensitivity at the BNC;
that is, after the probe factor is removed), the full bandwidth is
20 MHz.
TDS200 Series
At vertical scales of 5 mV/div or less (sensitivity at the BNC; that is,
after the probe factor is removed), the full bandwidth is 20 MHz.
When the acquisition mode is Peak Detect, and the vertical scale at
the BNC is 10 mV/div or less, the full bandwidth is also 20 MHz.
CH2:BANDWIDth ON
sets the bandwidth of channel 2 to 20 MHz.
CH1:BANDWIDth?
might return OFF, which indicates that there is no bandwidth
limiting on channel 1.
Group
Syntax
Arguments
Examples

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz