Tektronix TDS1002 Programmer's Manual

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−61
CURSor:HBArs:UNIts? (Query Only)
Returns the vertical scale units for the selected cursor source
waveform.
Cursor
CURSor:HBArs:UNIts?
VOLts indicates volts from ground as the unit of measure.
DIVs indicates divisions as the unit of measure, with center of screen
as 0 divisions and bottom of screen as –4 divisions.
DECIBELS indicates decibels as the unit of measure, relative to a
1 V
RMS
sine wave (FFT only).
UNKNOWN indicates that Trigger View is active. This also generates
event message 221 (Settings conflict).
CURSor:HBArs:UNIts?
might return CURSOR:HBARS:UNITS VOLTS
CURSor:SELect:SOUrce
Sets or queries the waveform that is the source of the vertical and
horizontal scale factors used in determining cursor values. This
command is equivalent to setting the Source option in the Cursor
menu.
Cursor
CURSor:SELect:SOUrce <wfm>
Group
Syntax
Returns
Examples
Group
Syntax

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz