Tektronix TDS1002 User Manual

TDS2CMA Communications Module
TDS1000/2000-Series Digital Oscilloscope User Manual
143
1 No connection
2 Receive data (RxD) (input)
3 Transmit data (TxD) (output)
4 Data terminal ready (DTR) (output)
5 Signal ground (GND)
6 Data set ready (DSR) (input)
7 Request to send (RTS) (output)
8 Clear to send (CTS) (input)
9 No connection
12345
67 8 9
Setting Up and Testing the GPIB Interface
You may need to set up and test the module GPIB interface. GPIB is
an 8-bit parallel communications standard that lets the oscilloscope
communicate with an external device such as a controller, computer,
terminal, or printer.
Connecting to External GPIB Devices
Follow these guideli nes when you connect your oscilloscope to a
GPIB network:
H Power off the oscilloscope and all external devices before
connecting the oscilloscope to the GPIB network.

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz