Tektronix TDS1002 User Manual

TDS2CMA Communications Module
150
TDS1000/2000-Series Digital Oscilloscope User Manual
Command Entry
When you enter oscilloscope commands over the RS-232 or GPIB
bus, follow these general rules:
H You can enter commands in upper or lower case.
H You can abbreviate many oscilloscope commands. These
abbreviations are shown in uppercase letters. For example, the
command ACQuire:NUMAVg can be entered simply as
ACQ:NUMAV or acq:numav.
H You can precede any command with white space characters.
White space characters include any combination of the ASCII
control characters 00 through 09 and 0B through 20 hexadecimal
(0 through 9 and 11 through 32 decimal).
H The oscilloscope ignores commands that consist of just a
combination of white space characters and line feeds.
Refer to the TDS200-, TDS1000- and TDS2000-Series Digital
Oscilloscope Programmer Manual (071-1075-XX) for more
information.

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz