Tektronix TDS1002 User Manual

TDS2CMA Communications Module
TDS1000/2000-Series Digital Oscilloscope User Manual
131
Sending Screen Data to an External Device
The TDS2CMA module lets you send screen data t o an external
device, such as a controller, printer, or comput er.
RS-232 connector
GPIB connector
Centronics connector
Printer Setup
To setup the module, do the following:
1. Power on the oscilloscope.
2. Push UTILITY
" Options " Printer Setup.
3. Push the option buttons to change the settings to match those of
your printer. The next table lists the settings you can change.
NOTE. The oscilloscope stores these settings until you change them,
even if you push the DEFAULT SETUP button.

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz