Tektronix TDS3000 Series User Manual

Trigger Controls
TDS3000 Series User Manual
3–51
Bottom Side Description
B T
ri
gg
er
A
f
ter
A
B Trigger After A
Time
Sets the oscilloscope to trigger on the
next B-trigger event that occurs after a
specified period of time from the A
trigger. Use the general purpose knob
to set the time value.
Set to Delay Time
(B
▼) then Set
(B
▼) to 0s
Sets the B Trigger After A Time value
to the horizontal B
▼ value, then
sets B
▼ to zero seconds. B▼ is
the delay time from the B trigger point
to the expansion point (center screen).
Set to Min Sets B Trigger After A time to 26.4 ns.
B Events Sets the oscilloscope to trigger on the
nth B-trigger event after the A trigger.
Use the general purpose knob to set
the event value.
Set to Min Sets the B events count to 1.
Source
Set
s
So
u
rce
,
co
up
li
ng, s
lo
p
e
, and
level or t e tri er e e etti
Coupling
level
f
or
t
h
e
B
tri
gg
er
. Th
e
s
e
s
etti
ngs
are independent of similar settings for
t e A tri er See e or
Slope
re i e e e t o imil r etti or
the A trigger. See page 3–55 for
e cri tio o t e e me item
Level
d
e
s
cri
p
tio
ns
o
f
t
h
e
s
e
me
nu
item
s.
The trigger wait time is the minimum time between the A and B
triggers. The trigger wait time is not the same as the horizontal delay
time. You can use the horizontal delay function to delay acquisition
relative to any trigger event, whether it is from the A trigger alone or
from a trigger setup that involves both the A and B triggers.

Tektronix TDS3000 Series Specifications

General

Brand	Tektronix
Model	TDS3000 Series
Category	Test Equipment
Language	English