Compliance information
Additional compliances
IEC 61010-1. Sa
fety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 1: General Requirements.
IEC 61010-2-0
30. Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 2-030: Particular
requirements for testing and measuring circuits.
Equipment type
Test and mea
suring equipment.
Pollution degree
descriptions
A measure of the contaminants that could occur in the environment around
and within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be use d only in the
environment for which they are rated.
Pollution degree 1. No pollution o r only dry, nonconductive pollution occurs.
Products in t his category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be exp
ected. This location is a typical o ffice/home environment. Temporary
condensation occurs only when the product is out of service.
Poll
ution degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
where neither temperature nor humidity is controlled. The area is protected
from direct sunshine, rain, or direct wind.
Pollution d egree 4. Pollution that generates persistent conductivity through
conductive dust, rain, or snow. Typical outdoor locations.
Pollution degree rating
Pollution degree 2 (as defined in IEC 61010-1). Rated for indoor, dry location
use only.
TPS2000B Series Digital Oscilloscope User Manual xi
To Next Page
Loading...
Need help?
General
