Compliance information
Australia / New Zealand
Declaration o f
Conformity – EMC
Complies with t
he EMC provision of the Radiocommunications Act per the
following standard, in accordance with ACMA:
CISPR 11. Radi
ated and Conducted Emissions, Group 1, Class A, in
accordance with EN 61326-1 and EN 61326-2-1.
FCC–EMC
Emissions are within the limits of FCC 47 CFR, Part 15, Subpart B for Class A
equipment.
Russian Federation
This product is approved by the Russian government to carry the GOST mark.
Safety co
mpliance
This section lists the safety standards with which the product complies and other
safety compliance information.
EU decla
ration of
conformity – l ow voltage
Compliance was demonstrated to the following specification a s listed in the
Official Journal of the European Union:
Low Voltage Directive 2006/95/EC.
EN 61010-1. Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use – Part 1: General Requirements.
EN 61010-2-030. Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 2-030: Particular
requirements for testing and measuring circuits.
U.S
. nationally recognized
testing laboratory listing
UL 61010-1. Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use – Part 1: General Requirements.
UL 61010-2-030. Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 2-030: Particular
requirements for testing and measuring circuits.
C
anadian certification
CAN/CSA-C22.2 No. 61010-1. Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use – Part 1: General
Requirements.
CAN/CSA-C22.2 No. 61010-2-030. Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use – Part 2-030:
Particular requirements for testing and measuring circuits.
x TPS2000B Series Digital Oscilloscope User Manual
To Next Page
Need help?
General
