Field Description
Select the Ethernet interface for which the virtual interface is to
be configured.
Address Mode Select how an IP address is assigned to the interface.
Possible values:
• *" (default value): The interface is assigned a static IP
address in IP Address / Netmask.
• .?2: An IP address is assigned to the interface dynamically
via DHCP.
IP Address / Netmask Only for Address Mode = *"
With Add, add a new address entry, enter the IP Address and
the corresponding Netmask of the virtual interface.
Interface Mode Only for physical interfaces in routing mode.
Select the configuration mode of the interface.
Possible values:
• 0 (default value): The interface is not assigned for a
specific purpose.
• ( 6/-': This option only applies for routing inter-
faces.
You use this option to assign the interface to a VLAN. This is
done using the VLAN ID, which is displayed in this mode and
can be configured. The definition of a MAC address in MAC
Address is optional in this module.
MAC Address Only with virtual interfaces and only for Interface Mode = 0
Enter the MAC address associated with the interface. For virtual
interfaces, you can use the MAC address of the physical inter-
face under which the virtual interface was created, but this is not
necessary. You can also allocate a virtual MAC address. The
first 6 characters of the MAC are preset (but can be changed).
VLAN ID Only for Interface Mode = ( 6/-'
Teldat GmbH
12 LAN
bintec Rxxx2/RTxxx2 147
To Next Page
Loading...
Need help?
General
