Field Description
within the existing connection are allowed.
In the NAT Configuration->Specify original traffic menu, you can configure for which
data traffic NAT is to be used.
Fields in the Specify original traffic menu.
Field Description
Service Not for Type of traffic = 3 *3" '-( and NAT
method = !3,,", #"" or )
#"".
Select one of the preconfigured services.
Possible values:
• 0#! (default value)
• A#" B
Action Only for Type of traffic = <",3 83 '-(
Select data packets to be excluded from NAT.
Possible values:
• <",3 (default value): All data packets will be excluded
from NAT if they match the subsequently specified paramet-
ers (Protocol, Source IP Address/Netmask, Destination IP Ad-
dress/Netmask, ect.).
• . <",3: All data packets will be excluded from
NAT if they do not match the subsequently specified paramet-
ers (Protocol, Source IP Address/Netmask, Destination IP Ad-
dress/Netmask, ect.).
Protocol Only for certain services.
Not for Type of traffic = 3 *3" '-( and NAT
method = !3,,", #"" or )
#"". In this case UDP is automatically defined.
Select a protocol. According to the selected Service, different
protocols are available.
Possible values:
Teldat GmbH
14 Networking
bintec Rxxx2/RTxxx2 201
To Next Page
Loading...
Need help?
General
