To carry out the switch proceed as follows:
Unscrew the two screws on the back of the device and slide the cover upwards.
The link plugs for the BRI-1 and BRI-2 interfaces can be found on all devices on the main
PCB behind the terminal block.
Insert the link plugs for interfaces BRI-1 and BRI-2 as shown in the following figure:
Use Interface Link plug area Position Position
Internal/external switching
BRI-1 J0M Internal external
Internal/external switching BRI-2 J1M Internal external
Power supply for internal con-
nection
BRI-1 J0P Off On
Power supply for internal con-
nection
BRI-2 J1P Off On
100 Ohm terminator BRI-1 J0T Off On
100 Ohm terminator BRI-2 J1T Off On
6 Variable switching of S0 interfaces Teldat GmbH
38 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
