Telegesis ETRX357-LR - Page 31

R309 AT Commands
©2015 Telegesis (UK) Ltd - 31 - AT Command Manual (Rev 3.09)
+POWERDESC – Request Node’s Power Descriptor (ZDO)
Execute Command
AT+POWERDESC:<Address>,
<Network address>
Where <Address> is the EUI64, Network
address or Address table entry of the node
which is to be interrogated about the node with
the Network address specified in <Network
address>.
Sends a unicast to obtain the specified device’s
power descriptor.
Use on
All Devices
Response
SEQ:XX
OK
or ERROR:<errorcode>
<errorcode> represents the error code explained
in section 3.
Prompt
PowerDesc:
<Network address>,<errorcode>
[,<PowerDescriptor>]
In case of an error an errorcode other than 00
will be displayed and the prompt will end after
the errorcode
<Network address> is the Remote node’s
Network address. In addition the power
descriptor is displayed as a 16 bit hexadecimal
number as described in section 2.3.2.4. of the
ZigBee specification.
As with all unicasts after successful transmission
the sequence number of the unicast is stated
using the “SEQ:XX” prompt. When
acknowledged (or not) the accompanying
“ACK:XX” (or “NACK:XX”) prompt is displayed.
SW release
R302 ●