Telegesis ETRX357-LR - 2.6 Module Control & Configuration Commands

R309 AT Commands
©2015 Telegesis (UK) Ltd - 15 - AT Command Manual (Rev 3.09)
2.6 Module Control & Configuration Commands
I – Display Product Identification Information
Execute Command
ATI
Response
Telegesis <DeviceName>
R<Firmware Revision>
<EUI64>
OK
Where <DeviceName> is the order code of the
device, <Firmware Revision> is the firmware
revision and <EUI64> is the Device’s IEEE
802.15.4 identifier
SW release
R300 ●
Z – Software Reset
Execute Command
ATZ
Response
JPAN:<channel>,<PID>,<EPID>
OK
or
OK
Module Performs a software reset
All non-volatile S Registers keep the user
defined values, if the module was part of a PAN
it will remain part of it.
SW release
R300 ●