R309 AT Commands
©2015 Telegesis (UK) Ltd - 65 - AT Command Manual (Rev 3.09)
3 List of Error codes
00 Everything OK - Success
01 Couldn’t poll Parent because of Timeout
02 Unknown command
04 Invalid S-Register
05 Invalid parameter
06 Recipient could not be reached
07 Message was not acknowledged
08 No sink known
09 Address Table entry is in use and cannot be modified
0A Message could not be sent
0B Local node is not sink
0C Too many characters
0E Background Scan in Progress (Please wait and try again)
0F Fatal error initialising the network
10 Error bootloading
12 Fatal error initialising the stack
18 Node has run out of Buffers
19 Trying to write read-only register
1A Data Mode Refused by Remote Node
1B Connection Lost in Data Mode
1C Remote node is already in Data Mode
20 Invalid password
25 Cannot form network
27 No network found
28 Operation cannot be completed if node is part of a PAN
2C Error leaving the PAN
2D Error scanning for PANs
33 No response from the remote bootloader
34 Target did not respond during cloning
35 Timeout occurred during xCASTB
39 MAC Transmit Queue is Full
6C Invalid Binding Index
70 Invalid Operation
72 More than 10 unicast messages were in flight at the same time
74 Message too long
80 ZDP Invalid Request Type
81 ZDP Device not Found
82 ZDP Invalid Endpoint
83 ZDP Not Active
84 ZDP Not Supported
85 ZDP Timeout
86 ZDP No Match
87 ZDP Table Full
88 ZDP No Entry
89 ZDP No Descriptor
To Next Page
Loading...