Telegesis ETRX357-LR - 2.8 Messaging

R309 AT Commands
©2015 Telegesis (UK) Ltd - 40 - AT Command Manual (Rev 3.09)
+CCHANGE – Change the network’s channel
Execute Command
AT+CCHANGE[:XX]
Ask all nodes in the network to change their
channel. If no channel is specified a random
channel out of the channels masked in S00 is
picked which wasn’t previously blacklisted
because of excessive packet loss (NM:ES
REPORT WARNING prompt)
Note
The New channel needs to be masked in in S00
for all nodes on the network. Ideally S00 should
be identical for all nodes on a network.
Use on
Network Manager
Response
OK
or
ERROR<errorcode>
<errorcode> represents the error code explained
in section 3.
Parameters
Optional XX ranging from 0B to 1A
SW release
R304 ●
2.8 Messaging
+ATABLE – Display Address Table
Read Command
AT+ATABLE
Notes
Entry 05 contains the address of the node’s sink.
The user can overwrite it to manually select a
different sink.
Entry 06 contains the address of the node
sending the most recently received UCAST,
SCAST or MCAST.
The address table is volatile and its contents are
lost if the device is powered down.
Use on
All Devices
Response
No. | Active | ID | EUI
00 | N | 0000
|000D6F0000012345
(…)
OK
The Address Table contains nodes which can be
addressed by referring to the corresponding
address table entry. The “Active” column shows
nodes to which a message is currently in flight.
SW release
R300 ●