Telegesis ETRX357-LR - Page 41

R309 AT Commands
©2015 Telegesis (UK) Ltd - 41 - AT Command Manual (Rev 3.09)
+ASET – Set Address Table Entry
Write Command
AT+ASET:XX,<Network address>,<EUI64>
Where XX is the entry number of the address
table entry which is to be written. If the Network
address is unknown, the Network address must
be substituted with “FFFF”.
Use on
All Devices
Response
OK
or ERROR:<errorcode>
<errorcode> represents the error code explained
in section 3.
SW release
R300 ●
+MTABLE – Display Multicast Table
Read Command
AT+MTABLE
Note
For Multicasts to be displayed using the MCAST
prompt, endpoint 01 must be selected as the
target endpoint.
The multicast table is cleared by a reset
Use on
All Devices
Response
No. | ID | EP
00 | 1234 | 01
01 | 0000 | 00
02 | 0000 | 00
03 | 0000 | 00
04 | 0000 | 00
OK
The multicast table contains all multicast IDs
which will be received by the local node.
SW release
R300 ●
+MSET – Set Multicast Table Entry
Write Command
AT+MSET:XX,<ID>,<endpoint>
Where XX is the index number of the multicast-
table entry which is to be written. For the AT-
Command interface operation the endpoint
should always be set to 01.
Note
SEDs and MEDs cannot receive multicast
messages
Use on
All Devices
Response
OK
or ERROR:<errorcode>
<errorcode> represents the error code explained
in section 3.
SW release
R300 ●