Telegesis ETRX357-LR - 2.5 AT Command Overview

R309 AT Commands
©2015 Telegesis (UK) Ltd - 13 - AT Command Manual (Rev 3.09)
2.5 AT Command Overview
The following table gives a quick reference of all commands available.
Command Overview
Module control and configuration
ATI
Display Product Identification Information
ATZ
Software Reset
AT+REMZ
Reset Remote Node
AT&F
Restore Factory Defaults
AT+BLOAD
Enter The Bootloader Menu
AT+PASSTHROUGH
Pass new Firmware Image To Remote Node
AT+RECOVER
Recover From A Failed Clone Attempt
ATS
S-Register Access
ATREMS
Remote S-Register Access
ATSALL
Remote S-Register Access
AT+TOKDUMP
Display All S-Registers
Network control and configuration
AT+ESCAN
Scan The Energy Of All Channels
AT+EN
Establish Personal Area Network
AT+PANSCAN
Scan For Active PANs
AT+JN
Join Network
AT+JPAN
Join Specific PAN
AT+SJN
Silent Join
AT+DASSL
Disassociate Local Device From PAN
AT+DASSR
Disassociate Remote Node From PAN (ZDO)
AT+N
Display Network Information
AT+NTABLE
Display Neighbour Table (ZDO)
AT+RTABLE
Display Routing Table (ZDO)
AT+IDREQ
Request Node’s Network address (ZDO)
AT+EUIREQ
Request Node’s EUI (ZDO)
AT+NODEDESC
Request Node’s Descriptor (ZDO)
AT+POWERDESC
Request Node’s Power Descriptor (ZDO)
AT+ACTEPDESC
Request Node’s Active Endpoint List (ZDO)
AT+SIMPLEDESC
Request Endpoint’s Simple Descriptor (ZDO)
AT+MATCHREQ
Find Nodes which Match a Specific Descriptor (ZDO)
AT+ANNCE
Announce Local Device in the Network (ZDO)
AT+SR
Set Source Route To Remote Device
AT+FNDSR
Find The Source Route To A Remote Device
AT+POLL
Poll For Data From Parent
AT+REJOIN
Rejoin The Network
AT+SN
Scan Network
AT+KEYUPD
Update the Network Key (ZDO)
AT+BECOMETC
Make Local Device the Trust Centre
AT+BECOMENM
Make the local device Network Manager
AT+CCHANGE
Change the network’s channel