Telegesis ETRX357-LR - Page 26

R309 AT Commands
©2015 Telegesis (UK) Ltd - 26 - AT Command Manual (Rev 3.09)
+NTABLE – Display Neighbour Table (ZDO)
Read Command
AT+NTABLE:XX,<address>
Where XX is the start index of the
remote LQI table and <address> can be
the remote node’s EUI64, Network
address or address table entry.
Note
Also the local node can be the target of
this command (e.g. use address table
entry FF as the address)
Use on
FFD, COO as the target device
Response
SEQ:XX
OK or ERROR<errorcode>
This command requests the target node to respond by
listing its neighbour table starting from the requested
index. Can be used to find the identity of all ZigBee
devices in the network including non-Telegesis devices.
Prompt (example)
NTable:<Network address>,<errorcode>
Length:03
No.| Type | EUI | ID | LQI
00.| FFD | 000D6F000015896B | BC04 | FF
01.| FFD | 000D6F00000B3E77 | 739D | FF
02.| FFD | 000D6F00000AAD11 | 75E3 | FF
In this example the neighbour table of the remote node
with the short ID shown in <Network address> contains
three entries (hexadecimal), which are displayed. In
case the table contains more than three entries it may be
required to repeat this command and increase the index
count until the full table is derived.
In case of an error an errorcode other than 00 will be
displayed and the prompt will end after the errorcode.
SW release
R302 ●