Telegesis ETRX357-LR - 4.2 S-Registers for Network Setup

R309 AT Commands
©2015 Telegesis (UK) Ltd - 70 - AT Command Manual (Rev 3.09)
4.2 S-Registers for Network Setup
S00 – Channel Mask
Description
The 802.15.4 channel mask.
Operations
R/W LOCAL
R/W REMOTE
Becomes effective
When Joining, Scanning or establishing a
PAN
Note
The channel mask does not affect the AT+JPAN
command
Storage
Non-Volatile
Parameters
XXXX
Where XXXX represents a 16-bit decimal
number enabling IEEE 802.15.4 channel
numbers 11 to 26.
Writing a bit to 1 enables a channel and
subsequently writing a bit to 0 disables a
channel for scanning, joining and establishing
networks.
e.g. when setting S00 to 0001, only channel 11
will be used for all following operations.
Range
0001 - FFFF
Factory Default
ETRX3 LRS-Variants: 7FFF
Others: FFFF
SW release
R302 ●
S01 – Transmit Power Level
Description
The device’s transmit power level in dBm.
Operations
R/W LOCAL
R/W REMOTE
Notes
The output power of the “-LRS” variant is higher
than the value in S01. Please refer to the
respective hardware manuals.
The ETRX357-LRS power is reduced for EC
regulatory compliance. See the hardware
manual.
Becomes effective
When Joining or establishing a PAN
Storage
Non-Volatile
Parameters
snn
Where snn represents a signed 8-bit decimal
number.
Range
ETRX3: 8 to -43
ETRX3 LRS Variants: -7 to -43
Actual values are {8, 7, 6, 5, 4, 3, 2, 1, -1, -2, -3,
-4, -5, -6, -7, -8, -9, -11, -12, -14, -17, -20, -26,
-43} Entering a value not on this list (such as
-19) will result in the next lowest output power.
Entering a value higher than 3 will automatically
enable boost mode regardless of the setting of
bit E of S11.
Factory Default
ETRX3 LRS-Variants: -17
Others: 3
SW release
R305 ●