Telegesis ETRX357-LR - Page 71

R309 AT Commands
©2015 Telegesis (UK) Ltd - 71 - AT Command Manual (Rev 3.09)
S02 – Preferred PAN ID
Description
The 802.15.4 PAN ID.
Operations
R/W LOCAL
R/W REMOTE
Becomes effective
When Joining or establishing a PAN
Notes
Two networks operating on the same channel
with the same PAN ID, but a different EPID are
detected to be in conflict with each other. PAN
ID conflicts are detected by the stack and
resolved by one of the networks dynamically
changing its PAN ID.
The preferred PID does not affect the AT+JPAN
command
Storage
Non-Volatile
Parameters
<PID>
Where <PID> represents a 16-bit hexadecimal
number
Range
0000 – FFFF
When establishing a PAN the coordinator will
pick a random PAN ID if S02 is set to 0000. If
set to any value between 0001 and FFFF this
number will be used as PAN ID instead, unless
trying to use a PAN ID which already exists on
the same channel. In this case a random PAN
ID will be used instead.
When joining only a PAN with the ID stored in
S02 will be joined unless S02 is set to 0000. In
this case the next best PAN which allows joining
is joined.
Factory Default
0000
SW release
R300 ●
S03 – Preferred Extended PAN ID
Description
The extended PAN ID.
Operations
R/W LOCAL
R/W REMOTE
Becomes effective
When Joining or establishing a PAN
Note
The EPID is used for PAN ID conflict detection.
It is therefore recommended to use a random
EPID at all times.
The preferred EPID does not affect the
AT+JPAN command
Storage
Non-Volatile
Parameters
<EPID>
Where <EPID> represents a 64-bit hexadecimal
number
Range
0000000000000000 – FFFFFFFFFFFFFFFF
When establishing a PAN the coordinator will
pick a random EPID if S03 is set to all 0’s. If set
to any other value this number will be used as
EPID instead.
When joining only a PAN with the EPID stored in
S03 will be joined unless S03 is set to all 0’s. In
this case the next best PAN which allows joining
is joined.
Factory Default
0000000000000000
SW release
R300 ●