Telegesis ETRX357-LR - 2.9 Binding Management (ETRX3 Series only)

R309 AT Commands
©2015 Telegesis (UK) Ltd - 58 - AT Command Manual (Rev 3.09)
2.9 Binding Management (ETRX3 Series only)
+LBTABLE – Display Local Binding Table
Read Command
AT+LBTABLE
Use on
All Devices
Response
No. | Type | Active | LocalEP | ClusterID | Addr | RemEP
10. | Ucast | No | 01 | DEAD | 1234567887654321 | 01
11. | MTO | No | 01 | DEAD | E012345678876543 | 88
12. | Mcast | No | 01 | DEAD | CDAB
13. | Unused
14. | Unused
15. | Unused
16. | Unused
17. | Unused
18. | Unused
19. | Unused
Entries in the local Binding Table.
SW release
R307 ●
+BSET – Set local Binding Table Entry
Write Command
AT+BSET:<type>,<LocalEP>,<ClusterID>,
<DstAddress>[,<DstEP>]
Where
<Type> is the type of binding as shown below,
<LocalEP> is the local endpoint
<ClusterID> is the cluster ID
<DstAddress> is either the EUI64 of the target
device, or a multicast ID
<DstEP> the destination endpoint which is not
specified in case of a multicast binding.
The new binding is created in the next available
free binding table entry.
Types:
1= Unicast Binding with EUI64 and destination
EP specified
2= Many to one Binding with EUI64 and
destination EP Specified
3= Multicast Binding with Multicast ID Specified
Example
AT+BSET:1,01,0002,000d6f000059474e,01
Note
All parameters must have exactly the correct
number of characters
Use mode 2 when the source or destination is a
coordinator or sink
Use on
All Devices
Response
OK
SW release
R307 ●