Telegesis ETRX357-LR - Page 28

R309 AT Commands
©2015 Telegesis (UK) Ltd - 28 - AT Command Manual (Rev 3.09)
+IDREQ – Request Node’s Network address (ZDO)
Execute Command
AT+IDREQ:<Address>[,XX]
Where <Address> can be a node’s EUI64, or
address table entry and XX is an optional index
number. In case an index number is provided,
an extended response is requested asking the
remote device to list its associated devices (ie
children).
Sends a broadcast to obtain the specified
Device’s Network address and optionally also
elements of its associated devices list.
Note
Providing FF as an address table entry
addresses the local node
Use on
All Devices
Response
OK
or ERROR:<errorcode>
<errorcode> represents the error code explained
in section 3.
Prompt
AddrResp:<errorcode>
[,<Network address>,<EUI64>]
[nn. <Network address>]
In case of an error an errorcode other than 00
will be displayed and the prompt will end after
the errorcode.
<EUI64> is the Remote node’s EUI64 and
<Network address> is its Network address. In
case an extended response has been requested
the requested Network addresses from the
associated devices list are listed as well.
SW release
R302 ●