Telegesis ETRX357-LR - Page 29

R309 AT Commands
©2015 Telegesis (UK) Ltd - 29 - AT Command Manual (Rev 3.09)
+EUIREQ – Request Node’s EUI64 (ZDO)
Execute Command
AT+EUIREQ:< Address>,
<Network address>[,XX]
Where <Address> is the EUI64, Network
address or address table entry of the node
which is to be interrogated about the node with
the Network address specified in <Network
address>. XX is an optional index number. In
case an index number is provided, an extended
response is requested asking the remote device
to list its associated devices (ie children).
Sends a unicast to obtain the specified device’s
EUI64 and optionally also elements of its
associated devices list (extended response).
Note
Providing FF as an address table entry
addresses the local node.
To find the EUI64 of an end device use its
parent’s address as the <Address> parameter.
Use on
All Devices
Response
SEQ:XX
OK
or ERROR:<errorcode>
<errorcode> represents the error code explained
in section 3.
Prompt
AddrResp:<errorcode>
[,<Network address>,<EUI64>]
[dd. <Network address>]
In case of an error an errorcode other than 00
will be displayed and the prompt will end after
the errorcode.
<EUI64> is the Remote node’s EUI64 and
<Network address> is its Network address. In
case an extended response has been requested
the requested Network addresses from the
associated devices list are listed.
As with all unicasts after successful transmission
the sequence number of the unicast is stated
using the “SEQ:XX” prompt. When
acknowledged (or not) the accompanying
“ACK:XX” (or “NACK:XX”) prompt is displayed.
SW release
R302 ●