Telegesis ETRX357-LR - Page 33

R309 AT Commands
©2015 Telegesis (UK) Ltd - 33 - AT Command Manual (Rev 3.09)
+SIMPLEDESC – Request Endpoint’s Simple Descriptor (ZDO)
Execute Command
AT+SIMPLEDESC:<Address>,
<Network address>,<XX>
Where <Address> is the EUI64, Network
address or Address table entry of the node
which is to be interrogated about the node with
the Network address specified in <Network
address> and XX is the number of the endpoint,
which simple descriptor is to be read.
Sends a unicast to obtain the specified device’s
active endpoint list.
Use on
All Devices
Response
SEQ:XX
OK
or ERROR:<errorcode>
<errorcode> represents the error code explained
in section 3.
Prompt
SimpleDesc:<Network address>,<errorcode>
EP:XX
ProfileID:XXXX
DeviceID:XXXXvXX
InCluster:<Cluster List>
OutCluster:<Cluster List>
In case of an error an errorcode other than 00
will be displayed and the prompt will end after
the errorcode
<Network address> is the Remote node’s
Network address. In addition all active
endpoints are listed as 8 bit hexadecimal
numbers separated by commas.
As with all unicasts after successful transmission
the sequence number of the unicast is stated
using the “SEQ:XX” prompt. When
acknowledged (or not) the accompanying
“ACK:XX” (or “NACK:XX”) prompt is displayed.
SW release
R302 ●