Telegesis ETRX357-LR - Page 24

R309 AT Commands
©2015 Telegesis (UK) Ltd - 24 - AT Command Manual (Rev 3.09)
+SJN – Silent Join
Execute Command
AT+SJN:<channel>,<TC EUI64>,
<NM Network address>,<nwk update ID>
“Silent” joining is joining via the commissioning
method. All data required to enter the network is
provided to the node, so that no joining
procedure itself is required. The node will
appear in the target network without any joining
procedure given the supplied data is correct.
The node can only join as a router, not an end
device
<channel> is a decimal number
Other parameters are hexadecimal
Example
AT+SJN:11,000D6F00000AAAD0,AFFE,00
Use on
All joining Devices
Response
JPAN:<channel>,<PID>,<EPID>
OK
or ERROR:<errorcode>
>
<errorcode> represents the error code explained
in section 3.
The local node will become part of the network
with the channel specified in <channel>, the
trust centre EUI64 specified in <TC EUI64>, the
Network address of the network manager
specified in <NM Network address>, the 8 bit
network update ID specified in <nwk update ID>,
the network key provided in S08, the trust centre
link key provided in S09, the PAN ID provided in
S02 and the extended PAN ID provided in S03.
Joining is still possible if the network update ID
is incorrect.
It is assumed that the key-sequence-number of
the network key is 0 when issuing this
command.
SW release
R305 ●
+DASSL – Disassociate Local Device From PAN
Execute Command
AT+DASSL
Note
Use with care on a Coordinator. It will not be
able to rejoin the PAN
Use on
All Devices
Response
OK or ERROR<errorcode>
Prompt
LeftPAN
<errorcode> represents the error code explained
in section 3.
Instruct local device to leave the PAN.
SW release
R300 ●