Telegesis ETRX357-LR - Page 36

R309 AT Commands
©2015 Telegesis (UK) Ltd - 36 - AT Command Manual (Rev 3.09)
+SR – Set Source Route to Remote Device
Execute Command
AT+SR:<Network address>,
<Network address>,…
Set the source route of a message sent to a
remote device, starting with the Network
address of the remote device, followed by all
Network addresses on the route from the remote
node to the local node starting at the remote end
Note
Setting up invalid routes may lead to listed
devices becoming unavailable. To confirm a
route use AT+FNDSR.
Use on
All Devices
Response
OK
or
ERROR<errorcode>
<errorcode> represents the error code explained
in section 3.
Stores route information for up to 30 hops which
will be used when sending any message to a
remote node, which is part of the listed devices.
SW release
R300 ●
+FNDSR – Find the Source Route to a remote device
Execute Command
AT+FNDSR:<address>
Where <address> can be the remote node’s
EUI64 or address table index
Tries to find source route information to the
specified device by sending a ZDO request to
the remote device and thus triggering a reply.
Use on
COO, Sink
Response
OK
or
ERROR<errorcode>
Prompt
SR:XX,<EUI64>,<Network
address>,<Network address>…
Where XX represents the number of hops to the
remote node, EUI64 its EUI64 number followed
by a list of Network addresses starting with the
remote node listing all nodes along the path to
the local node
<errorcode> represents the error code explained
in section 3.
SW release
R302 ●