Telegesis ETRX357-LR - Page 64

R309 AT Commands
©2015 Telegesis (UK) Ltd - 64 - AT Command Manual (Rev 3.09)
+SYNCTIME - Synchronize the Local Time with Time Server
Execute Command
AT+SYNCTIME:<Node ID>,
<End Point>[,Profile ID]
<Node ID> : Target node address
<End Point> : Target node’s end point
<Profile ID>: Profile ID used for the request,
if unspecified 0x0104 (HA) will be used
Note
The target shall support the time server cluster.
To exchange this message without interfering
with any of the other message types, the local
endpoint 0x63 (99) is used for this exchange.
Response
OK
or ERROR:<errorcode>
followed by
Prompt:
SYNCINGTIME:<time>
<errorcode> represents the error code explained
in section 3
SW release
R309 ●