MCC201/MCC201H User manual
4. Remote Configuration • 39
E-mail Notification
Specify the information to send event information, when E-mail is selected as an event action.
- Server Address: Enter an address of mail (SMTP) server.
- Port: Specify a port for SMTP operation (Port 25 is the default port in SMTP operation.
If a different port is configured in the SMTP server, this port needs to be changed accordingly).
- Sender Address: Enter an account registered in the SMTP server.
- Authentication on SMTP server: Specify if the E-mail server requires authentication for E-mail sending.
- ID & password: When the server requires authentication, ID and Password of an E-mail account need
to be entered.
- Destination address: Enter Destination address. More than one address can be entered by delimiting
comma (,) or semi-colon (;). Destination address can take up to 63 characters.
- Video Clip Attaching: Video clip stored at the moment of event can be attached as an AVI or JPEG file
format. When dual encoding is enabled, Primary video, Secondary video (H.264 only) or JPEG
Capture can be selected. The duration of video clip can be configured with Pre-Event Time and Post-
Event Time in Event Record section.
- Number of Frame: The number of JPEG frames is configured. This setting is applicable only when JPEG
Capture is selected.
- E-mail Test: E-mail sending can be tested with this button. Please note that configured settings should
be saved first by pressing Apply button before using E-mail Test function. One of the following messages
will come as a result of the test.
Message Description
E-mail sent successfully
Test E-mail has been sent successfully.
Reception in the client can be checked.
Failed to connect SMTP server
Connection to the SMTP server failed. It is necessary to check if the
server is reachable and server address and port are correct.
Authentication failed
The server is reachable but authentication failed.
ID and/or password need to be checked.
SMTP server rejected the mail
The server is reachable, but mail sending failed due to a reason
other than authentication. This error happens often when the server
authenticates according to its own rule. For example, IP addresses
of a specific range or addressed of a specific suffix are allowed.
To Next Page
Loading...
