Teletype 28 - Page 122

SECTION 573-118-700TC
3.42 Automatic and Remote Control Noninterfering LTRS and BLANK Tape
Feed Out Mechanisms (continued)
TIME DELAY LEVER SPRING
Requirement
With unit in stop position
Min 2 oz---Max 3 oz
to pull spring to installed
length.
(C) RATCHET RETURN SPRING
Requirement
With unit in stop position
Min 5 oz---Max 7 oz------.
to pull spring to installed length.
RESET CAM FOLLOWER
ON HIGH PART OF CAM
RESET BAIL CAM IN
STOP POSITION
(A) TIME DELAY LEVER
(1) Requirement
Page 122
Trip selector clutch and rotate
main shaft until reset cam fol-
lower is on high part of reset
bail cam.
Min 0. 040 inch---Max 0. 060 inch
clearance between time delay lever
and high part of time de lay cam.
/ /
/ /
/ /\ ""LATCHLEVER
/ /
/ RATCHET RETURN
Requirement
SPRING
ECCENTRIC
BUSHING
TIME DELAY
CAM
(Front Vlew)
With
unit in stop position
t-----Min some
clearance between time delay lever and
high part of time delay cam.
To Adjust
With clamp screw loosened, position
eccentric bushing. Tighten screw.