Televes
®
11
Front & rear pannel LEDs
The product has 5 LED’s on its front pannel show different working conditions of the device. Furthermore 3
LED’s on the rear pannel show status and activity of the ethernet ports.
Power LED
This LED shows the status of the device.
Green: Normal working conditions.
Orange: Device is booting and loading configuration. The product will use this colour to indicate
configuration events such as the activation of the WPS mode.
Red: Indicates that the device has detected an error while booting.
Internet LED
This LED indicates the status of the connection to the internet.
Green: The device is connected to the internet.
Red: The device is not connected to the internet. Verify all connections of the equipment and the
correct configuration of the gateway supplied by the ISP.
Orange: The device has been configured to AP Bridge. In this working mode there is a bridge
between the three interfaces Ethernet-Coaxial/PLC-WiFi.
WLAN LED
This LED shows the status of the WiFi network.
Green: WiFi is On. Maximum output power +17 dB.
Orange: WiFi is ON in low power mode. Maximum output power is +3 dBm.
Red : WiFi en OFF.
Medium Coaxial / Hybrid LED
Shows the selected transmission medium on the front pannel switch.
Green. Coaxial only.
Orange. Hybrid, Coaxial + PLC. Connection stablished through both coaxial & power line network.
Link status LED
This LED indicates both the quality of the connection and the activity on the coaxial/power line interface.
• Green: Higher quality connection.Optimal performance.
• Orange: Good quality connection.
• Red: Poor quality connection.
Ethernet LED’s
Each back pannel ethernet port has an LED indicating link up as well as activity on the port. Each RJ45
port supports speed autonegotiation.
www.televes.es
ENGLISH
To Next Page