User manual
“SCART DVB-T 7117
”
45
ENGLISH
When the receiver is first turned on, it will show an initial installation window.
This menu consists of four options: OSD Language, Area, LCN and Enabled
Aerial.
To set up these parameters, follow the instructions below:
Using buttons / locate the cursor on the language window.
Using buttons CH+ / CH- select the desired menu language.
The available menus are: English, French, German, Italian, Spanish,
Swedish, Portuguese, Finnish, Dutch, Turkish, Czech, Greek and
Danish.
Press button OK to confirm.
Shift the cursor to the next optionn Area using the button CH-.
Using buttons / locate the cursor on the country window.
Using buttons CH+ / CH- select the zone for local configuration of
parameters.
The areas or zones available are: Germany, England, Italy, France,
Spain, Holland, Taiwan, China, Norway, Sweden, Finland, Greece and
Australia.
Press button OK to confirm.
Shift the cursor to the next option LCN using button CH-.
Using buttons / locate the cursor on the options window.
Using buttons CH+ / CH- select the enabling (on) or disabling (off)
of the LCN option (Automatic channel organizing).
Press button OK to confirm.
Move the cursor to the next option Active Antenna using button CH-.
Using buttons / locate the cursor on the options window.
Using buttons CH+ / CH- indicate if you wish to feed (on) or not (off)
a potential amplifier into the aerial.
If no amplifier is available, you should select the Off option, otherwise
you might damage the receiver.
Press button OK to confirm.
5.- Start of installation
To Next Page
Loading...
Need help?
General