User manual
“SCART DVB-T 7117
”
52
This receiver allows programmes to be recorded in two different ways: in
real time, or by using the “Wakeup Timer” option.
To use this function, you must have an external disk or pen drive in FAT 32
format, which must be connected before plugging the receiver into the
mains.
- Before starting the recording, press the / keys to show the list of
devices. Select the device using the CH+ / CH- keys, and then press
OK on the device. A confirmation message will be shown.
- Press the EXIT key to exit the device list.
Real time recording
- Press the RECORD (red) key once to record the programme you are
currently watching. The letters “REC” will the shown on the screen, and
you will not be able to access any other programme. If you press this
key twice, you will be able to define how long the recording lasts (15, 30,
45, 60, 75, 90, 105 or 120 minutes), and then confirm using the OK key.
- If the signal level drops or disappears during the recording, the message
“REC PAUSE” will be shown on the screen, and the recording will halt.
Recording will begin again once the signal returns.
- To stop recording, press the EXIT key. A message will be shown asking
you if you want to stop the recording, by selecting YES or NO.
Recording with Wakeup/EPG
- There are two ways of programming a recording, either through the
information of the EPG or directly using the Wakeup option.
- For information on how to create events indicating the start time and
end time for recordings, programme, etc., see section 11.3.5.- Wakeup
Timer Configuration.
NOTES:The recordings will be stored in files with a maximum size of 3.8
GB (due to the 4GB limit of the FAT 32 format).
Subtitles will not be available while recording a programme.
9.- Recording programmes
To Next Page
Loading...
Need help?
General