User manual
“SCART DVB-T 7117
”
61
ENGLISH
11.3.3.- System Configuration
Using this menu, you can configure the system parameters.
Equalizer
Using buttons CH+ / CH- locate the cursor on the “Equalizer”
parameter, and using buttons / select the kind of equalizer you desire.
The options are: Standard, Classical, Rock, Jazz or Pop.
Surround
Using buttons CH+ / CH- locate the cursor on the “Surround”
parameter, using buttons / to select the desired effect.
The options are: Off, Concert, Church, Passive and Direct.
Active Antenna
If you are using an active aerial (with amplifier) you should enable this
option to feed the respective amplifier with +5V/100mA. The feeding is
done through the selfsame coaxial cable that is connected to the RF IN
port of the receiver.
To do so, using buttons CH+ / CH- locate the cursor on parameter
“Active antenna” and with buttons / enable (on) the feed process.
If no amplifier is available, you should select the option “Off”,
otherwise the receiver may be damaged.
JPEG Effect
This option enables you to give the picture a similar effect to that of
JPEG.
To do so, using buttons CH+ / CH- locate the cursor on parameter
“JPEG Effect”, and with buttons / enable (on) the effect.
LCN
This option allows you to enable or disable the LCN Function (Automatic
Channel Organizing).
To do so, using buttons CH+ / CH- locate the cursor on parameter
“LCN” and with buttons / enable (on) or disable (off) this option.
Note: The enabling of this option affects the way in which the receiver
automatically organizes channels when it is carrying out a channel
search.
Area
This option enables the selection of the area or zone where the receiver
will be located.
To do this, using buttons CH+ / CH- locate the cursor on parameter
“Area”. With buttons / switch to the zone list, and with buttons
CH+ / CH- select the desired country. Press OK to accept.
Note: The selection of a given area determines default parameters.
Finally, press button OK to confirm the parameters you have changed.