Televes SCART DVB-T 7117 User Manual

User manual “SCART DVB-T 7117 ”
58
- This option allows the user to enable or disable the feed on a potential
aerial amplifier.
- To do so, once you have chosen the option “Antenna Setting” press
button OK to accept. You will thus access a sub-menu in which you
should enable (on) or disable (off) the amplifier feed using buttons / .
Note: If there is no amplifier, you must select the option NO, otherwise
you can damage the adaptor.
- Finally, press button OK to confirm.
11.2.6.- Antenna Setting
- Select this mode to carry out a selective search between two
frequencies.
- To do so, once you have selected the option “Range Search” press
button OK to accept. You will thus access a sub-menu where you
should indicate both the starting and ending frequencies.
- Select the appropriate Bandwidth among 6, 7 or 8 MHz using buttons
/ .
- Finally, press button OK to start the search.
- Bear in mind that if these values are not the correct ones, the search will
fail.
- Finally, press button OK to start the search.
You can follow the search process using the indications shown on the TV
screen.
11.2.4.- Range Search
- This option allows the user to enable or disable the channel organization
mode that has been defined by the operator.
- To do so, once you have selected the option “LCN Setting” press
button OK to accept. You will access a sub-menu where you can enable
(on) or disable (off) the automatic organizing mode with buttons / .
- Finally, press button OK to confirm.
11.2.5.- LCN Setting

Televes SCART DVB-T 7117 Specifications

General

Brand	Televes
Model	SCART DVB-T 7117
Category	TV Receiver
Language	English