Telex C-2000HS - Clone Mode Overview; Setup State 30 Full Duplex Mode Enable;Disable; Setup State 31 Handset Enable;Disable

C-2000 and C-2000HS Technical Manual Setup 33
Bosch Security Systems, Inc. Technical Manual F.01U.174.927 Rev 03
Clone Mode Overview
ENTER(#) key: Used to enter Clone Mode.
ESCAPE(*) key: Used to exit Clone Mode.
DTMF B: Sets up the slave/receive mode. Must be done prior to receiving data.
DTMF A: Starts data transmission from the master. Slave will indicate Clone Complete.
Setup State 30 Full Duplex Mode Enable/Disable
The Full-Duplex Mode Enable/Disable is used to set whether the C-2000 has the full-duplex mode of operation enabled or
disabled. Full-Duplex allows the operator to listen to incoming traffic during a PTT sequence.
Setup State option:
1=Enable*
2=Disable
To enable/disable full duplex mode, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press Enter (#).
Display shows OC (Option Changed).
Setup State 31 Handset Enable/Disable
The Handset Enable/Disable is used to set whether the C-2000 has the handset enabled or disabled. This is used to determine
the routing of receive audio.
Setup State option:
1=Enable*
2=Disable
To enable/disable the handset, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press Enter (#).
Display shows OC (Option Changed).