18 Setup C-2000 and C-2000HS Technical Manual
Bosch Security Systems, Inc. Technical Manual F.01U.174.927 Rev 03
Exiting Setup Mode
Exiting Setup Mode is done in the same manner as entering setup mode.
1. Press and hold the IC and MON keys.
2. Press the 2 key.
The user returns to normal operation mode.
NOTE: Settings are saved on exit.
To save settings before exiting setup mode, do the following:
1. Press and hold the IC and MON keys.
2. Press the D key.
Maneuvering Through Setup Mode
Setup Mode Control Keys
The main control keys are:
Volume Up and Down - Selects the setup state by scrolling up and down through the allowed states.
Function Up and Down - Selects the setup option for the current setup state by scrolling through the allowed options
for that state.
DTMF Found Key (#) - Used as the Enter key. Pressing this key enters the current option for the current state. It also
takes you into a more complicated mode if more than a simple enable or disable is required.
DTMF Star Key (*) - Used as the Escape key. Pressing this key exits without saving from certain setup states that
require it.
NOTE: Only a few states use this key.
DTMF A and B Keys - These keys are used to program Function Tone frequencies main and sub-tone. It is also
used to select clone mode master or slave.
IC and D Key - Pressing and holding IC, then pressing D saves the changes made to setup mode.
IC and MON Keys - Pressing these keys together while in the PIN change state disables the PIN.
NOTE: This key sequence is not used in any other state.
Transmit Key - This key is used to display the current setup state, once the display has changed to the setup
option.
Setup Mode Philosophy
Once Setup Mode is entered, the operator uses the volume up and down keys to select the setup state. The setup state is the
system function that the operator wishes to change or enable. The display shows the setup state number and both decimal
points for one (1) second and then change to the Setup State option number, with no decimal point, that is currently
programmed.
If you want to review the setup state while the set up option is being displayed, simply press the TRANSMIT key on the front
panel and the current setup state displays as long as the key is held. Once you have scrolled to your desired setup state and the
display has changed to that states currently programmed setup option, the operator can use the function up and function down
keys to scroll to the appropriate setup option.
To Next Page
Loading...