6 Introduction C-2000 and C-2000HS Technical Manual
Bosch Security Systems, Inc. Technical Manual F.01U.174.927 Rev 03
Features
C-2000HS Features
The C-2000HS is shipped from the factory in the following state:
• 4-wire mode
• Full-duplex
• TX monitor enabled
• F3–F16 disabled
• 600 Ohm TX output impedance
• 600 Ohm RX input impedance
C-2000 Features
The C-2000 is shipped from the factory in the following state:
• 4-wire mode
• Full-duplex
• TX monitor enabled
• F3–F16 Disabled
• 600 Ohm TX output impedance
• 600 Ohm RX input impedance
• Handset disabled
• Desk microphone enabled.
Display Character Description
CC (Clone Complete) - Cloning is successful.
CL (Clone Mode) - Clone mode is entered.
CD (Crossmute) - Another parallel console is active and pull crossmute low.
CP (Correct PIN) - The PIN number is correctly entered.
EE (Error) - An error occurred, seen in clone mode if cloning fails.
EP (Enter Pin) - A PIN number needs to be entered to access setup mode.
FD (Function Duration) - Function duration programming mode is entered.
FF (Function Frequency) - Function frequency programming mode is entered.
IP (Incorrect PIN) - An incorrect PIN number was entered.
OC (Option Changed) - The option selected is changed.
PC (PIN Changed) - The PIN was successfully changed.
SS (Settings Saved) - The current settings are permanently saved.
SU (Supervisor) - The supervisor pin is activated by a parallel console.
To Next Page
Loading...