Telex C-2000HS - Setup State 49 Alert Tone Enable;Disable; Setup State 50 Alignment Tone On;Off

C-2000 and C-2000HS Technical Manual Setup 41
Bosch Security Systems, Inc. Technical Manual F.01U.174.927 Rev 03
Setup State 49 Alert Tone Enable/Disable
The Alert Tone Enable/Disable is used to enable/disable alert tone capability, this feature allows an alert tone to be
transmitted as long as the A key is pressed and held. The tone is a high/low warble tone at 0 dBm.
Setup State option:
1=Enable
2=Disable*
To enable/disable alert tone capability, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press ENTER (#).
Display shows OC (Option Changed).
NOTE: If this feature is enabled, the A key is not available for normal DTMF use.
Setup State 50 Alignment Tone On/Off
The Alignment Tone On/Off is used to turn an alignment tone on and off, this feature is used to assist the system setup. The
tone frequency is 1050Hz at 0 dBm. All the control is done in this setup mode.
Setup mode option:
1=On
2=Off*
To turn an alignment tone on and off, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press ENTER (#).
Display shows OC (Option Changed).