Telex C-2000HS - Setup State 43 EMSTEL Enable;Disable (Special Software Option); Setup State 44 DTMF Sequence Entry

38 Setup C-2000 and C-2000HS Technical Manual
Bosch Security Systems, Inc. Technical Manual F.01U.174.927 Rev 03
Setup State 43 EMSTEL Enable/Disable (Special Software Option)
The EMSTEL Enable/Disable is used to enable/disable the EMSTEL mode of operation. This mode is to operate in
multi-party, 4-wire private network. It uses two (2) digit DTMF signaling.
Setup State option:
1=Enable
2=Disable*
To enable/disable EMSTEL, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press Enter (#).
Display shows OC (Option Changed).
NOTE: If SF Mode is enabled, EMSTEL Mode is disabled. Disable SF Mode before exiting setup mode.
Setup State 44 DTMF Sequence Entry
The DTMCF Sequence Entry is used to program the DTMF sequences which cause annunciation if received or is transmitted
when the D key is pressed and the sequence assignment number follows directly, providing the mode is enable
(see DTMF Sequence Enable/Disable and DTMF Keypad Enable/Disable).
NOTE: When this feature is enabled, the D key is unavailable for normal DTMF use.
To enter a DTMF sequence, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press ENTER (#).
3. Enter the DTMF sequence.
Which is to be received or transmitted.
4. Press the A key.
Terminates the sequence. Display will show OC (Option Changed).
Setup Option Assignment
1D00
2D01
3D02
4D03
5D04
6D05
7D06
8D07
9D08
10 D09
11 D10
12 D11
13 D12
14 D13
15 D14
16 Receive/D15