Telex C-2000HS - Setup State 35 Squelch Enable;Disable; Setup State 36 Squelch Hang Time; Setup State 37 TX Monitor Enable;Disable

C-2000 and C-2000HS Technical Manual Setup 35
Bosch Security Systems, Inc. Technical Manual F.01U.174.927 Rev 03
Setup State 35 Squelch Enable/Disable
The Squelch Enable/ Disable enables or disables the squelch function. If disabled, all audio, no matter the incoming level, is
played through to the speaker.
Setup State option:
1=Enable
2=Disable*
To enable/disable the squelch, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press Enter (#).
Display shows OC (Option Changed).
Setup State 36 Squelch Hang Time
The Squelch Hang Time duration can vary from 1 to 60s and is configurable to the nearest second. The squelch hang time
determines the amount of time the squelch stays open after a valid signal is removed. The Setup State option number is the
value, in seconds, to be programmed. The default value is 10 seconds.
To configure squelch hang time, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press Enter (#).
Display shows OC (Option Changed).
Setup State 37 TX Monitor Enable/Disable
The TX Monitor Enable/Disable enables or disables the TX monitor function. In 4-wire mode, if TX monitor is enabled,
parallel TX audio is routed to the speaker. Also, the tone detector algorithm blinks the TRANSMIT LED when threshold
surpassing hold tone is detected on the TX line. In 2-wire mode, this feature is not applicable.
Setup State option:
1=Enable*
2=Disable
To enable/disable TX monitor function, do the following:
1. Select the setup option using FUP/FDWN keys.
2. Press Enter (#).
Display shows OC (Option Changed).