Telit Wireless Solutions ME910C1-WW - DRX at Commands; Edrx Setting - +CEDRXS






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page101of233

+CPSMS – Power Saving Mode Setting
(<Units(0-2)><TimerValue(0-31)> in bits)
Notes
How to manage timer values octet.
T3412 value:
Bits 5 to 1 represent the binary coded timer value.
Bits 6 to 8 defines the timer value unit as follows:
Bits
8 7 6
0 0 0 value is incremented in multiples of 10 minutes
0 0 1 value is incremented in multiples of 1 hour
0 1 0 value is incremented in multiples of 10 hours
0 1 1 value is incremented in multiples of 2 seconds
1 0 0 value is incremented in multiples of 30 seconds
1 0 1 value is incremented in multiples of 1 minute
1 1 0 value is incremented in multiples of 320 hours
1 1 1 value indicates that the timer is deactivated.
Example: 10100010 -> 101 means values is incremented in multiples of 1
minute, 10 means 2 -> the obtained value is 2 minutes
T3324 value:
Bits 5 to 1 represent the binary coded timer value.
Bits 6 to 8 defines the timer value unit for the GPRS timer as follows:
Bits
8 7 6
0 0 0 value is incremented in multiples of 2 seconds
0 0 1 value is incremented in multiples of 1 minute
0 1 0 value is incremented in multiples of decihours
1 1 1 value indicates that the timer is deactivated.
Reference 3GPP TS 27.007

eDRX AT Commands
eDRX setting - +CEDRXS
+CEDRXS - eDRX setting
AT+CEDRXS=[<mode>,[,<
AcT-
type>[,<Requested_eDRX_
value>]]]
Set command controls the setting of the UEs eDRX parameters. The
command controls whether the UE wants to apply eDRX or not, as well as the
requested eDRX value for each specified type of access technology.
Parameter: