Telit Wireless Solutions ME910C1-WW - Clear GPS Data

To Next Page

To Previous Page



AT Commands Reference Guide

80529ST10815A Rev.2– 2017-09-14



ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page230of233



<cid> - a numeric parameter which specifies a particular PDP

context definition (see +CGDCONT command)

Note: <cid> is mandatory if <mode> is set to lock, otherwise

shall be omitted.

Note: the set command returns ERROR if the current cid and/or

the previously set are in use. Note: The current setting is stored

in NVM.

AT$LCSLK?

Read command returns the current value of parameters <mode>

and

<cid> (if <mode> is lock).

AT$LCSLK=?

Test command returns the range of values for parameters

Clear GPS Data - $GPSCLRX

$GPSCLRX – Clear GPS Data

AT$GPSCLRX

This command resets all of the parameters related with GPS

Resets all parameters related with GPS as following:

- GPS Almanac Data

- GPS Ephemeris Data

- LBS User Plane PDE IP Address

- LBS User Plane PDE IP Port

Note: This command is global and cannot clear individual pieces

of data.

AT$GPSCLRX =?

Test command returns the OK result code

Example

AT$GPSCLRX=?

AT$GPSCLRX

Telit Wireless Solutions ME910C1-WW - Clear GPS Data - GPSCLRX