Telit Wireless Solutions ME910C1-WW - Manufacturer Identification - +GMI; Model Identification - +GMM; Revision Identification - +GMR; Serial Number - +GSN






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page28of233

&P - Default Reset Full Profile Designation
Parameter:
<n>
0...1 – profile number: the wireless module is able to store 2 full configurations (see
command &W).
Note: differently from command Z<n>, which loads just once the desired profile, the
one chosen through command &P will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as AT&P0
Reference
Telit Specifications
Manufacturer Identification - +GMI
+GMI - Manufacturer Identification
AT+GMI
Execution command returns the manufacturer identification.
Reference V.25ter
Model Identification - +GMM
+GMM - Model Identification
AT+GMM
Execution command returns the model identification.
Reference
V.25ter
Revision Identification - +GMR
+GMR - Revision Identification
AT+GMR
Execution command returns the software revision identification.
Reference
V.25ter
Serial Number - +GSN
+GSN - Request Product Serial Number Identification
AT+GSN
Execution command returns the device board serial number.
Note: The number returned is not the IMSI, it is only the board number.
Reference V.25ter