Telit Wireless Solutions ME910C1-WW - GPS Stop Location Service Request - GPSSTOP; Update SLP Address - SLP






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page224of233

Example
AT$GPSSLSR= 2,3,,,,,1
OK
Note
- The current setting is stored through $GPSSAV
- Power up clears GPS memory and then starts the GPS
receiver. GPS data cleaning is performed on the base of the
current value of the <reset_type> parameter (see $GPSR)
.
GPS Stop Location Service Request - $GPSSTOP
$GPSSTOP – GPS Stop Location Service Request
$GPSSTOP=
[<abort_cause>]
Command used to stop the Receiver in Autonomous or A-GPS
mode initiated through $GPSSLSR set command.
Parameter:
<abort_cause>
0: User denies the request
1: Unspecified cause for abort
2: Cause Invalid
AT$GPSSTOP? Read command returns the current value of parameter
<abort_cause>.
$GPSSTOP=?
OK
Example
AT$GPSSTOP=1
OK
Note
The current setting is stored through $GPSSAV.
The default factory value is ‘1’, it can be recovered by $GPSRST.
Update SLP address - $SLP
$SLP - Update SLP address
AT$SLP=<slp_address_type>
[,<slp_address:slp_port>]
Set command allows updating the SLP address and
SLP port number. Parameters:
<slp_address_type>: SLP address type
0 - IPv4
1 - FQDN
3 – IPv6
<slp_address>: SLP address in FQDN format,
IPv4 or IPv6 format
<slp_port_number> : Slp Port number integer
parameter. Default value is 7275.